2-part replacement "treads" that go OVER the existing rubber treads on the Alphard CyberCart wheels. One half has PINS and the other half has HOLES. Both wheel treads are the same, just reverse one if you want the treads to point the same direction on each wheel. I recommend that the center of the tread points forward.

You place the inside one over the wheel by squeezing it a bit, then push it onto the inside, then place the outside one on, and line up the pins, while making sure the "anti-slip buttons" on the inside of the new treads line up with one of the existing tread indentations.

You can either use zip ties (available as an add-on) or, using a clamp, apply LocTite 406 TPU CA (super glue) or equivalent CA (CA MUST be TPU compatible) to each outer tread part where the pin is, clamp the two sides together, then move to the next pin and repeat. Do this for the entire wheel, using plenty of super glue. Repeat for other tire. You can also use BOTH super glue and zip ties if you wish.

Installation instructions included with each set.

Available in Black, White and Gray.

Color samples:

**** ALLOW 3-4 WEEKS FOR